Skip to main content Help Control Panel

. Sanglier Volant - Flying wild boar

Total performance Aircraft - Construction d'un avion Van's RV8

F811B Bar problem

While drilling fuselage skin, i had drill into F811B Bar. F811B Bar F811B Bar painting Fuselage elements reassembly before riveting fuselageLa réponse de Gus 5h seulement après avoir posé la question, Merci Gus.

Van's answer (Gus):
You could blend out the gouge from the drill, but as the parts are removed from the airplane, I think the best thing would be to replace
the 811B. It's not very expensive and would not require much work  to do.

It's a good idea to use a drill stop when there is something behind the hole to be drilled, or at least put a scrap piece of aluminum behind where the hole will be so the drill will hit that when it breaks through. Removing F811B Bar for replacing by new one
Page précédente - Page suivante

 
Share
* Invite participants
* Share at Facebook
* Share at Twitter
* Share at LinkedIn
* Reference this page
* Save as PDF
* Copy in MS-Word
* Print this page
Monitor
Recent files
Fuselage »
See also