F811B Bar problem
Posted by Sangliervolant on Sep. 22 2006, page edited by Sangliervolant on Nov. 12 2006, (popular)
While drilling fuselage skin, i had drill into F811B Bar.
La réponse de Gus 5h seulement après avoir posé la question, Merci Gus.Van's answer (Gus):
You could blend out the gouge from the drill, but as the parts are removed from the airplane, I think the best thing would be to replace
the 811B. It's not very expensive and would not require much work to do.
It's a good idea to use a drill stop when there is something behind the hole to be drilled, or at least put a scrap piece of aluminum behind where the hole will be so the drill will hit that when it breaks through.
Page précédente - Page suivante
podcasted files